Delta Electronics TP08 Bedienungsanleitung PDF herunterladen (Seite 48)

1 TPEditor Operation

1-46

Figure 1-83

Step 2. In Circle Meter Setting tab, the users can set Refer Device, Value Type, Value Length, Integer Num

(Number), Decimal Num (Number), Max Value, Min Value, Style, Font Setting, Main Scale and Sub

Scale.

Step 3. Style could be 300 Degrees or 360 Degrees. It indicates that a circle could be 300 degrees or 360

degrees (Figure 1-84).

Figure 1-84

Step 4. After complete the settings, TP series will read the values of the corresponding PLC registers, convert

the read values to be a circle meter and display on the screen of TP series.

Step 5. Click View(V) > Object Inspector command from the menu bar, a Property tab will show up on the

screen and display all the properties of the Meter object. The users also could change the settings of

the Meter object directly by using the drop-down lists in Property tab.

■ Message Display

Step 1. After choose Object(O) > Message Display(M) command from the menu bar or click the icon

the toolbar, move the mouse on the editing screen area, the cursor will be a +. Left click and drag the

mouse in the editing screen area. After releasing the mouse, the square

will be made on the

screen. Double-click the square

by using the mouse, the following Message Display Setting tab

will pop up. The users can set the Refer Device to Bit or Value at this time (Figure 1-85).

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 99 100

Keine Kommentare

Delta Electronics TP08 Bedienungsanleitung Seite 48