Delta Electronics TP08 Bedienungsanleitung PDF herunterladen (Seite 63)

1 TPEditor Operation

1-61

D100 = actual sampling points

D101 = 1

point of 1

curve

D102 = 1

point of 2

curve

D103 = 2

point of 1

curve

and vise versa.

TP series will convert the values into two curves and display them on the screen. (The settings of

Vertical Max and Vertical Min are used to the range of the read registers. If the value exceeds the

range, it will not be displayed on the curve.

Step 3. Click View(V) > Object Inspector command from the menu bar, a Property tab will show up on the

screen and display all the properties of the selected object. The users also could change the settings of

the selected object directly by using the drop-down lists in Property tab.

■ X-Y Curve

Step 1. After choose Object(O) > X-Y Curve(X) command from the menu bar or click the icon

on the

toolbar to create a X-Y Curve object on the screen. Double-click the selected object by using the mouse,

the following X-Y Curve Setting tab will pop up (Figure 1-107).

Figure 1-107

Step 2. The sampling rule is described as follows:

For example, when the Refer Device is set to D0, TP series will regard the value of D0 as the value of

sampling points and its maximum could be 100 points. The combination of D1 and D2 will become the

first point of X- and Y- axis, the combination of D3 and D4 will become the second point of X- and Y-

axis, … and vise versa. Then, The odd numbers are defined as one group (D1, D3, …) and the even

numbers are defined as another group (D2, D4, …). Then, a X-Y curve could be drawn and displayed

on the screen.

Suppose that Refer Device is D100, then

D100 = actual sampling points

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 99 100

Keine Kommentare

Delta Electronics TP08 Bedienungsanleitung Seite 63