Delta Electronics TP08 Bedienungsanleitung PDF herunterladen (Seite 54)

1 TPEditor Operation

1-52

Figure 1-91

Step1. The setting steps are similar to the ON/OFF buttons. Only some options are different. Please refer to

the introduction of ON/OFF buttons.

Step 2. Set the Value Length and Value Type. Value Length could be 16 Bits or 32 Bits. Value Type could be

Unsigned, Signed, Hex and BCD.

Step 3. Set the Value Format. Integer Number and Decimal Number are used to set the display value and its

decimal places. For example, suppose that the value of 0, if Integer Number is set to 3 and Decimal

Number is set to 2, the display value will be 000.00. If Max Value is set to 5000 at this time, the actual

display value will be 050.00. If Max Value is set to 500 at this time, the actual display value will be 5.00

and vise versa. The Max Value and Min Value could be determined in the Rage Limit. Using this

function can prevent the typing error.

Step 4. After complete all settings, click OK button to finish and the button will be used as it is configured.

Constant setting Button: When this button is pressed, TP series will sent the specified constant settings to

the corresponding PLC registers immediately. The settings are the same as the Input Value Button. The users

can enter the desired constant value in the field of Constant Setting (Figure 1-92).

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 99 100

Keine Kommentare

Delta Electronics TP08 Bedienungsanleitung Seite 54