Delta Electronics TP08 Bedienungsanleitung PDF herunterladen (Seite 59)

1 TPEditor Operation

1-57

Step 5. Click View(V) > Object Inspector command from the menu bar, a Property tab will show up on the

screen and display all the properties of the Clock Display object. The users also could change the

settings of the Clock Display object directly by using the drop-down lists in Property tab.

■ Multi-State Bitmap/Label(T)

Multi-State Bitmap/Label: After TP series reads the corresponding PLC contacts (ON or OFF) or the value of

PLC register, using this object can automatically display the edited text and input picture for each

corresponding state on the screen of TP series directly.

Step 1. After choose Object(O) > Multi-State Bitmap/Label(T) command from the menu bar or click the icon

on the toolbar to create a Multi-State Bitmap/Label object on the screen. Double-click the object by

using the mouse, the following Multi-State Bitmap Setting tab will pop up (Figure 1-100). The settings

and usage of Multi-State Bitmap/Label object are the same as Dynamic Bitmap. But the difference is

that it is able to input text and display the Multi-State Bitmap/Label object. The Refer Device could be

Bit or Value device.

Figure 1-100

Figure 1-101

Step 2. When the Refer Device is set to Value, the Display Sequence could be either “From Max to Min” or

“From Min to Max” (Figure 1-101).

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 99 100

Keine Kommentare

Delta Electronics TP08 Bedienungsanleitung Seite 59