Delta Electronics TP08 Bedienungsanleitung PDF herunterladen (Seite 45)

1 TPEditor Operation

1-43

on the screen. Please note that if the Device Value is smaller than 100, no picture will display as the

users do not specify its Current State and display picture. The setting range value of Current State 0

should be the greater than the setting range value of Current State 1, the setting range value of Current

State 1 should be the greater than the setting range value of Current State 2, the setting range value of

Current State 2 should be the greater than the setting range value of Current State 3, and vise versa.

Step 5. When the users double click the field of “Device Value >= Range Value” by using the mouse, the

following All States Table tab shown in Figure 1-77 will open for the users to set the setting range

values of all states.

Figure 1-77

Step 6. After pressing Refer Value button, the following Edit Range Calculator tab (Figure 1-78) will appear and

it could help to calculate the setting range value for all states.

Figure 1-78

Step 7. Click View(V) > Object Inspector command from the menu bar, a Property tab will show up on the

screen and display all the properties of the Dynamic Bitmap object. The users also could change the

settings of the Dynamic Bitmap object directly by using the drop-down lists in Property tab.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 99 100

Keine Kommentare

Delta Electronics TP08 Bedienungsanleitung Seite 45