Delta Electronics TP08 Bedienungsanleitung PDF herunterladen (Seite 47)

1 TPEditor Operation

1-45

■ Bar Graph

Step 1. Choose Object(O) > Bar Graph(P) command from the menu bar or click the icon

on the Toolbar.

Then, move the mouse on the editing screen area, the cursor will be a +. Left click and drag the mouse

in the editing screen area. After releasing the mouse, the square

will be made on the screen.

Double-click the square

by using the mouse, the following Bar Graph Setting tab will pop up

(Figure 1-82).

Figure 1-82

Step 2. In Bar Graph Setting tab, the users can set Refer Device, Value Type, Value Length, Direction Setting,

Max Value and Min Value.

Step 3. Direction Setting option is used to set the increasing direction of the value of the Bar Graph.

Step 4. Max Value and Min Value are used to set the range of the display value. When these two options are

set, it indicates that only the value between the minimum and maximum will shows on the Bar Graph.

Step 5. After complete the settings, TP series will read the values of the corresponding PLC registers, convert

the read values to be a Bar Graph and display on the screen of TP series.

Step 6. Click View(V) > Object Inspector command from the menu bar, a Property tab will show up on the

screen and display all the properties of the Bar Graph object. The users also could change the settings

of the Bar Graph object directly by using the drop-down lists in Property tab.

■ Meter

Step 1. Choose Object(O) > Meter(E) command from the menu bar or click the icon

on the Toolbar. Then,

move the mouse on the editing screen area, the cursor will be a +. Left click and drag the mouse in the

editing screen area. After releasing the mouse, the square

will be made on the screen. Double-

click the square

by using the mouse, the following Circle Meter Setting tab will pop up (Figure 1-

83).

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 99 100

Keine Kommentare

Delta Electronics TP08 Bedienungsanleitung Seite 47