Delta Electronics VFD-L Series Spezifikationen Seite 41

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 134
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 40
5
VFD-M Series
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
5-15
Value Function Value Function
08 Multi-Step Speed Command 3 09 Jog Operation
10 Accel/Decel Speed Inhibit 11
First or Second Accel/Decel Time
Selection
12
External Base Block (N.O.)
(Normally Open Contact Input)
13
External Base Block (N.C.)
(Normally Close Contact Input)
14 Increase Master Frequency 15 Decrease Master Frequency
16 Run PLC Program 17 Pause PLC Program
18 Counter Trigger Signal 19 Counter Reset
20 No Function
21
RESET Command (N.C)
22 Control source: External Terminal 23 Control source: Keypad
24 Control source: Communication 25
Parameter Lock (Write disable, Read is
always 0)
26
PID Disable (N.O.)
27
PID Disable (N.C.)
28
Second Source for Frequency
Command
29
Forward (contact is open) / Reverse
(contact is close)
30
One-Shot PLC Run
31
Index Input Signal
32
Virtual Timer Input
Explanations:
00: no function.
01, 02:
when it is set to 01 or 02, AC drive output will stop immediately. If there is start signal
after stopping, the output will start from the minimum frequency.
03, 04 External Faults:
Parameter values 3 and 4 program Multi-Function Input Terminals:
M1 (Pr.38), M2 (Pr.39), M3 (Pr.40), M4 (Pr.41) or M5 (Pr.42) to be
External Fault (E.F.) inputs.
GND
E.F.(N.O.)
setting by 3
E.F(N.C.)
setting by 4
Mx "Close": Operation available.
Mx "Open":Operation available.
Note: When an External Fault input signal is received, the AC drive output will turn off, drive will
display
E.F. on Digital Keypad, and the motor will coast. Normal operation can
resume after the External Fault is cleared and the AC drive is reset.
05 External Reset:
Parameter value 5 programs Multi-Function Input Terminals: M1 (Pr.38), M2 (Pr.39), M3
(Pr.40), M4 (Pr.41) or M5 (Pr.42) to be an External Reset.
Seitenansicht 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 133 134

Kommentare zu diesen Handbüchern

Keine Kommentare