Delta Electronics VFD-L Series Spezifikationen PDF herunterladen (Seite 57)

VFD-M Series

5-31

Pr.60

Over-Torque Detection Mode Factory Setting: 00

Settings 00 Over-Torque detection disabled.

Enabled during constant speed operation until the allowable time fo

detection (Pr.62) elapses.

02 Enabled during constant speed operation and halted after detection.

Enabled during acceleration until the allowable time for detection

(Pr.62) elapses.

04 Enabled during acceleration and halted after detection.

Pr.61

Over-Torque Detection Level

Factory Setting: 150

Settings 30 to 200% Unit: 1%

 A setting of 100% is proportional to the Rated Output Current of the drive.

 This parameter sets the Over-Torque Detection level in 1% increments. (The AC drive

rated current is equal to 100%.)

Pr.62

Over-Torque Detection Time Factory Setting: 0.1sec

Settings 0.0 to 10.0sec Unit: 0.1 sec

 This is the duration for over-torque detection. When the output current is larger than the

over-torque detection level (Pr.61), an over-torque condition exists and the detection time

(Pr.62) is timed-out. Any of the multi-function output terminals set to indicate over-torque,

will then close. (Please refer to Pr. 45 and Pr.46)

Pr.63

Loss of ACI (4-20mA) Factory Setting: 00

Settings 00 Decelerate to 0 Hz

01 Stop immediately and display "EF"

02 Continue operation by last frequency command

Pr.64

User Defined Function for Display Factory Setting: 06

Settings 00

Displays AC drive output frequency (Hz)

Display User-defined output Frequency (H*Pr.65)

Output Voltage (E)

DC Bus Voltage (u)

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 133 134

Keine Kommentare

Delta Electronics VFD-L Series Spezifikationen Seite 57