Delta Electronics AC Drive VFD-F Series Spezifikationen PDF herunterladen (Seite 38)

VFD-F Series

5-5

01 - 04

Mid-point Voltage Factory Setting: 5.5/11.0

Settings 230V series: 0.1 ~ 255.0V

460V series: 0.2 ~ 510.0V

 This parameter sets the Mid-point Voltage of the V/f curve.

 This parameter must meet the following argument. Pr.1-02 >= Pr.1-04 >= Pr.1-06.

01 - 05

Minimum Output Frequency Factory Setting: 1.50

Settings 0.10~20.00 Hz

 This parameter sets the Minimum Output Frequency of the AC drive. This parameter must be lower

than or equal to the Mid-point frequency

01 - 06

Minimum Output Voltage Factory Setting: 5.5/11.0

Settings 230V series: 0.1 ~ 50.0V

460V series: 0.2 ~100.0V

 This parameter sets the Minimum Output Voltage of the AC Drive. The parameter must be lower

than or equal to the Mid-point Voltage.

01 - 07

Upper Bound Frequency Factory Setting: 60.00

Settings 0.00~120.00 Hz

 This parameter will limit the maximum output frequency of AC drive. If slip compensation

(Pr.07-02~07-05) or feedback control (Pr.10-00~10-09) are enabled, the output frequency of AC

drive may exceed the Master Frequency Command, but it will continue to be limited by this

parameter setting.

01 - 08

Lower Bound Frequency Factory Setting: 0.00

Settings 0.00~120.00 Hz

 This parameter will limit the minimum output frequency. Any Master Frequency Command below

Pr.1-08 will result in an output equal to Pr.1-08.

 Upon a start command, the drive will accelerate from Pr.1-05 Minimum Output Frequency to the

Master Frequency Command point.

 The Lower Bound Frequency setting must be smaller than the Dwell Frequency (Pr.11-08>=01-08).

If lower bound frequency setting is greater than the Dwell Frequency, the AC drive will equalize the

two settings to the Lower Bound point.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 189 190

Keine Kommentare

Delta Electronics AC Drive VFD-F Series Spezifikationen Seite 38