Delta Electronics AC Drive VFD-F Series Spezifikationen PDF herunterladen (Seite 85)

VFD-F Series

5-52

09 - 07

Communication Frequency Setting



Factory Setting: 60.00

Settings 0~120.00Hz Unit: 0.01

 This parameter can be set by communication settings. It can’t be set by keypad.

09 - 08

Communication Operation Command 2



Factory Setting: 00

Settings

Bit0: 1: EF ON

Bit1: 1: Reset

Bit2: 0: BB OFF, 1: BB ON

Bit3~15: Reserved

 This parameter can be set by communication settings. It can’t be set by keypad.

 If you set BB action by this parameter and you also need to disable BB action by this parameter.

There is a built-in RS-485 serial interface, marked (RJ-11 jack) on the control terminal block. The

pins are defined below:

1: EV

2: GND

3: SG-

4: SG+

5: NC

6: for communication

Each AC drive has a pre-assigned communication address specified by 9-00. The computer then

controls each AC drive according to its communication address.

AC drive can be setup to communicate on Modbus networks using one of the following modes:

ASCII (American Standard Code for Information interchange) or RTU (Remote Terminal Unit).

Users can select the desired mode along with the serial port communication protocol in 09-04 and

09-05.

09-09 Switching between Modbus & BACnet



Factory Setting 00

Setting

Range

00 Modbus Mode

01 BACnet Master Mode

02 BACnet Slaver Mode

 This parameter determines the switch between Modbus and BACnet.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 189 190

Keine Kommentare

Delta Electronics AC Drive VFD-F Series Spezifikationen Seite 85